hockey arcade game How to Make a Penny Hockey Game

by:BLEE     2019-06-30










Penny hockey is a simple game of copying hockey, replacing the stick with a Penny instead of rubber puck and fingers.A penny is placed on the board with a hole at both ends representing the target.The player takes turns to flick the coin in an attempt to get it into the opponent's target.To increase the difficulty, the wooden nail "defender" is placed around the board, bouncing back a penny while flashing, and blocking their angle at the goal.Mark a plywood rectangle 12 inch long and 8 1/2 wide and cut out with a saw.Mark a pair of 8-centered points1/2 of width every 8 2 inch-1 A point 1/2inch edge.Drill through these points with 1/2inch bit.Mark a point in the center of the plywood.Mark a pair of 3 inch points from one end of 8 1/2-Inch side, each point from a 12-1/4inch side.Repeat at the other end of the board, create a pair of points "goal posts" on both sides of the two scoring holes ".Mark a pair of 4 1/2 points from one end of 8 1/2Inch side, each point from a 12-1/4inch side.Repeat at the other end of the board, create a pair of points \ "defenders \" on both sides of the board \".Drill through these points with 1/4inch bit.At 1/4 each-The inch hole of the wood glue, so the end of the pin is flush with the bottom of the plywood.Cut two plywood sheets 12 inch long and 2 inch wide.Glue and clamp the rectangle on its 1/4-Inch side of the top of the ice rink, outside edge with a 12-The inch side of the ice rink, the second outer edge with the other 12-An inch side of the ice rink, making side panels for the ice rink.In order to avoid players being stuck on the back wall, there is no end board for the skating rink.
Custom message
Chat Online 编辑模式下无法使用
Chat Online inputting...